Amplifier Settings; Signal Input And Output Configurations; Input Gain; Line Output Configurations - Orion HP-2800 Owner's Manual

AMPLIFIER SETTINGS

Signal Input and Output Configurations

Depending on your model, the input section of the amplifier consists of gain controls, high
pass and low pass crossovers controls, Intelli-Q control, Intelli-Bass control and RCA inputs
and outputs. The input section makes it easy to adapt this amplifier to most system config-
urations.

Input Gain

These Orion amplifiers have level adjustments to allow for easy integration with any source
unit. The input sensitivity can be adjusted from 150mV to 5V. Refer to Testing the System
and Adjusting the Sound of the System sections of this guide for detailed instructions on
setting the gain.

Line Output Configurations

The line outputs on Orion amplifiers offer easy system expansion. Routing signal from the
RCA line outputs to the next Orion amplifier's RCA line inputs in the signal chain.

Internal Crossover Configurations

The crossover section of the Orion amplifier is continuously variable and extremely flexible.
In addition to the variable built-in low-pass filters, the high-pass crossover incorporates the
INTELLi Q feature. This circuit is designed to optimize the performance of Orion subwoofers
in all types of enclosures.
When using Orion loudspeakers, minor deviations from the recommended frequency
ranges can provide superior results depending on your speaker locations and your vehicle
acoustics. Setting crossover frequencies higher than recommended will not cause damage
and may provide superior sonic results depending on your system's performance goals.
Refer to your loudspeaker owner's manual for assistance in choosing the proper crossover
frequencies for your system.
WARNING! DO NOT set crossover frequencies lower than the speakers recommended
operating range. This can cause driver failure that is not covered by the man-
ufacturer's warranty.

Crossover Switch

Controls the type of filter for the onboard active crossover. The HP-4800 has two switches,
the upper switch is for channels 1/2, the lower switch is for channels 3/4.
Full position does not attenuate any frequencies and is for full range speaker systems.
High attenuates low frequencies and is used for mid-range speakers and tweeters.
Low attenuates high frequencies and is used for subwoofer speakers.

Intelli-Q

Intelli-Q is incorporated in the HP-2800, and only on the rear channels of the HP-4800.
Additionally, boost can be added by means of the Intelli-Q adjustment at the high-pass
crossover frequency for improved bass output while still protecting the woofer from exces-
sive excursion. The INTELLi-Q adjustment allows up to 10 dB of boost at the selected
crossover frequency.
© 2005 Directed Electronics, all rights reserved
9