Manual Setting Of All Route Points - Navitel E100 User Manual

Manual Setting of All Route Points

To plot a route where both the starting and the destination points are determined manually, first mark a point on the map where
you plan to begin your route, and then tap "Cursor" [1] to proceed to the "My route" screen. Tap the information panel at the
bottom of the screen [2]. Select "Set start" in the "Properties" screen [3]. The program will request that you switch the GPS-receiver
off. The point will be marked on the map as a starting point. Select a destination point on the map: tap on the map to mark the
point, select "Cursor" [4], and then in the "My route" screen tap "Go!" [5]. The program will plot a route [6].
Fig. 1
Fig. 4
QUick start gUide - navitel e100
Fig. 2
Fig. 5
| 49
EN
Fig. 3
Fig. 6