Table of Contents
Advertisement
Troubleshooting
The majority of faults which could occur in
daily operation can be rectified by the
user. This ensures that the appliance is
quickly available for use again. The
following overview will help you locating
the causes and gives helpful advise to
eliminate them.
Note
If the appliance stops during dishwashing
or does not start for no obvious reason,
first run the Abort programme function
(Reset).
(See chapter entitled "Dishwashing")
ã=
Warning
Don't forget: Repairs may be carried out
by technicians only. If a component has to
be replaced, ensure that only original
spare parts are used. Improper repairs or
use of non-original spare parts may cause
considerable damage and put the user at
considerable risk.
Downloaded from DishWasher-Manual.com Manuals
Waste water pump
Large food remnants in the rinsing water
not retained by the filters may block
the waste water pump. The rinsing water
is then not pumped out and covers
the filter.
In this case:
– First disconnect the appliance from
the power supply.
– Remove the filters 1J.
– Scoop out water, use a sponge if
required.
– Loosen screw on the cover (Torx T 20)
and remove the cover.
7RU[ 7
– Check inner compartment and remove
any foreign objects.
– Re-insert cover and screw tight.
– Re-insert the filters and screw tight.
... when the appliance is
switched on
The appliance does not start.
– The mains fuse has tripped.
– The appliance plug has not been
inserted.
– The appliance door has not been shut
properly.
en
19
Advertisement
Table of Contents
