Safety instructions The electrical connection Delivery conditions must correspond 1. Check the packaging and with the specifications dishwasher immediately for on the dishwasher rating plate 9:. damage caused in transit. Do not switch on a damaged If the power cord of this appliance, but contact your appliance is damaged, supplier.
Safety instructions Some models: Disposal The plastic housing on the 1. Make redundant appliances water connection contains unusable to prevent an electric valve, subsequent accidents. the connecting cables 2. Dispose of the appliance in a are in the supply hose. n environmentally friendly Do not cut through this hose, manner.
Safety instructions ã= Keep children away from Warning open dishwasher. Risk of explosion! The water in the rinsing Do not add any solvents compartment is not drinking to the washing chamber. water and could contain Danger of explosion! detergent residue. Ensure that children do not ã= Warning...
Water softening system/Special salt Appliance interior Water softening system/Special salt 1" Interior light * s a l t e m / S p e c i a l n g s y s t s o f t e n i W a t e r 1* Top basket To ensure good washing results,...
Water softening system/Special salt To change the setting: Using special salt 1. Press programme button 3. Always refill with special salt Each time the button is pressed, the immediately before switching on the set value increases by one level; appliance. This ensures that overrun when the value of : has been special salt solution is immediately...
Rinse aid 1. Open the dispenser 9" by pressing Switching off salt refill and lifting the plate on the cover. indicator/water softening system Sw i t c h i n g of f w a t e r so f t e n i n g s y s t e m If the salt refill indicator @ is impaired (e.g.
Utensils Setting amount of rinse aid Switching off rinse aid refill indicator The amount of rinse aid can be set from . Please set rinse aid on If the rinse-aid refill indicator H is to obtain very good drying results impaired (e.g.
Utensils Glass and utensil damage Unloading the dishwasher Causes: To prevent water from dripping off the upper basket onto the utensils in the Glass type and glass production lower basket, it is recommended process. to empty the appliance from the bottom Chemical composition of the detergent.
Utensils Pans Cutlery basket Bottom basket 1j You should always place cutlery unsorted with the points downwards. To prevent injuries, place long, pointed implements and knives on the knife shelf. F olding spikes * Fo l d i n g s p i k e s Heavily soiled utensils (pans) should * depending on model be placed in the bottom basket.
Utensils Small accessories holder * Appliance height 81.5 cm Sm a l l ac c e s s o r i e s ho l d e r Top basket Bottom * depending on model basket Light-weight plastic accessories, e.g. Setting 1 max.
Detergent Top basket with upper and Note lower roller pairs To ensure a good washing result, always follow the instructions on the detergent packaging! 1. Pull out the top basket 1* out. If you have further questions, 2. Remove the upper basket and re- we recommend that you contact attach it to the upper (stage 3) or the detergent manufacturers’...
Detergent 2. Close the cover on the detergent Combination detergent dispenser by sliding it up until the lock engages without difficulty. Apart from conventional detergents (Solo), a number of products are offered with additional functions. These products contain not only the detergent but also rinse-aid and salt replacement substances (3in1) and, depending on the combination (4in1, 5in1, etc.),...
Detergent Notes You will obtain optimum rinsing and drying results by using solo detergents and applying salt and rinse aid separately. If programmes are short, tablets may not have full cleaning effect due to different dissolving properties and there may even be undissolved detergent residue.
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia.
Additional options § Information for test institutes Half load * Ha l f l o a d Test institutes receive the information for If you have only a few items to wash comparability tests (e.g. according to (e.g. glasses, cups, plates), you can EN60436).
Operating the appliance Optical display while Remaining running time Op t i c a l d i s p l a y wh i l e t h e p r o g r a m m e i s r u n n i n g the programme is running * display * depending on model...
Operating the appliance End of programme The setting can be selected from : The programme has ended when the Appliance does not value : is indicated on the numerical switch off automatically. display h. The interior light 1" The end of the programme is also comes on when the door indicated by an acoustic signal.
Cleaning and maintenance To change the setting, To ensure that the door seal always remains clean and hygienic, regularly 1. Press the button 3 to switch the clean it with a damp cloth and a little Intensive drying on : or off : washing-up liquid.
Cleaning and maintenance Filters Spray arms The filters 1Z keep large foreign Limescale objects in the rinsing water away from and contaminants in the rinsing water the pump. These foreign objects may may block nozzles and bearings on the spray arms 1B occasionally block the filters.
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display 8 lights up. Tap turned off. Turn on the tap. Tap jammed or calcified. Turn on the tap. Flow rate must be min.
Fault, what to do? Fault Cause Remedial action A different error code is A technical fault has probably Switch off appliances with the ON/OFF switch (. After a short time restart indicated on the digital occurred. display. the appliance. to : If the problem recurs, turn off the tap and pull out the mains plug.
Fault, what to do? Fault Cause Remedial action Utensils not dry. No or too little rinse aid Refill rinse aid. in the dispenser. Programme selected without Select programme with drying (see drying. Overview of programmes, Programme sequence). Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
Fault, what to do? Fault Cause Remedial action Food remnants Utensils placed too closely Arrange utensils with adequate clearance on the utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
Fault, what to do? Fault Cause Remedial action Water stains on plastic Droplet formation on plastic Use a more intensive programme (more parts surface is physically unavoidable. water changes). After drying, water stains are Arrange utensils in a sloping position. visible.
Fault, what to do? Fault Cause Remedial action Coloured (blue, yellow, Film formation consisting Can be partly removed with machine brown), difficult to remove of ingredients from vegetables cleaner or by mechanical cleaning. Coatings to non-removable coatings (e.g. cabbage, celery, potatoes, are harmless.
Fault, what to do? Fault Cause Remedial action Rust spots on the cutlery. Cutlery not adequately rust- Use corrosion-resistant cutlery. resistant. Knife blades are frequently more severely affected. Cutlery will also rust if rusting Do not wash rusting parts. parts are rinsed at the same time (pan handles, damaged utensil baskets, etc.).
Fault, what to do? Fault Cause Remedial action Appliance stops Door not closed properly. Close the door. in the programme or Do not place utensils or fragrance Check whether rear panel is being pressed programme is interrupted. dispenser in the tablet collecting in, e.g.
Customer service Customer service Installation and connection e r v i c e C u s t o m e r s If you are unable to rectify the fault, i o n a n d c o n n e c t l a t i o n I n s t a l please contact your customer service.
Installation and connection Safety instructions Installation Please follow the safety instructions The required installation dimensions can under “Installation”. be found in the installation instructions. Level the appliance with the aid of the height-adjustable feet. Ensure that the Delivery appliance is situated securely on the floor.
Installation and connection Fresh water connection Warm water connection * Wa r m wa t e r co n n e c t i o n 1. Connect the fresh-water connection * depending on model to the tap according to the The dishwasher can be connected installation instructions with the to cold or hot water up to max.
Installation and connection To change the setting: Removing the appliance 1. By pressing the 3 button, you can switch the hot water setting off : Also observe or on the sequence of worksteps here. 2. Press START button `. 1. Disconnect the appliance from The set value is saved.
Installation and connection Transportation Protection against frost Pr o t e c t i o n a g a i n s t fr o s t ( E m p t y i n g t h e a p p l i a n c e ) Empty the dishwasher and secure loose If the appliance is in a room where there parts.