Table of Contents
Advertisement
en
Water softening system
To ensure good washing results, the
dishwasher requires soft water, i.e.
containing low amounts of lime, otherwise
white limescale will be deposited on the
utensils and inner container.
Tap water above 9° Clarke must be
softened. The water is softened with salt
(regeneration salt) in the water softening
system of the dishwasher.
The setting and therefore the required
amount of salt depends on the degree of
hardness of your tap water (see table).
Setting
The amount of salt dispensed can be set
from
to .
Sal is not required at the set value .
– Find out about the hardness
value of your tap water. Your water
utility company will help you with this.
– Set value can be found in the water
hardness table.
– Close the door.
– Hold down programme button +
and switch on the main switch (.
– Release both buttons.
The LED for button + flashes
and the digital display 8 displays
the factory setting .
To change the setting:
– Press programme button +.
Each time the button is pressed,
the set value increases by one level;
when the value of
the display jumps back to
– Switch off the main switch (
The chosen setting has now been
stored.
6
Downloaded from DishWasher-Manual.com Manuals
has been reached,
(off).
Water hardness table
:DWHU
+DUGQHVV
KDUGQHVV
UDQJH
YDOXH
ƒ&ODUNH
VRIW
VRIW
PHGLXP
PHGLXP
PHGLXP
KDUG
KDUG
KDUG
PPROO
6HW YDOXHâRQâ
WKHâPDFKLQH
¯
³
›
´
ž
‚
±
Å
Advertisement
Table of Contents
