Connection; Operating The Indoor Antenna - Silvercrest TDT SZA 28 A1 Operating Instructions Manual

Connection

Place the device on a firm and level surface.
Connection to a television
Connect the antenna cable of the indoor anten-
na 6 to the antenna socket of your television.
The antenna cable of the indoor antenna
only be connected directly to the TV if the TV
has a built-in DVB-T Tuner.
Connection as a radio aerial
When you want to use the room antenna for
radio reception, utilise the Adapter Coaxial
socket/Coaxial socket
Connect the Adapter Coaxial socket/Coaxial
socket 8 with the antenna cable.
Connect the anntenna cable with Adapter
Coaxial socket/Coaxial socket
75 Ohm connector on your stereo system.
Connection to a DVB-T receiver
Connect the antenna cable of the indoor
antenna 6 to the antenna socket of the DVB-T
Receiver.
To connect the room antenna to a DVB-T-
Receiver with an F-socket, the Adapter F-Plug/
Coaxial socket 7
Connect the Adapter F-Plug/Coaxial socket
with the antenna cable.
Screw the antenna cable with the Adapter
F-Plug/Coaxial socket
DVB-T-Receivers.
Power source connection
Insert the power plug of the indoor antenna
into the power socket.
6
8 .
8 to the
must be used.
7 to the F-socket of the

Operating the Indoor Antenna

Receiving programme signals via the
indoor antenna
The programme signals are received by the indoor
antenna and transmitted to the television set.
For the reception of DVB-T transmitter signals you
can need a TV with an integrated DVB-T Tuner or an
additional DVB-T Receiver (DVB-T signals are not
available everywhere).
The indoor antenna has to be positioned correctly
for the proper reception of programme signals.
The following antennas are available for this:
1 two telescoping antennas for VHF and UKW
reception that tilt and rotate by 180° and
2 one oval-shaped antenna for UHF reception
that tilts and rotates by 100°.
To orient the indoor antenna:
Pull out both telescopic antenna
and adjust these until the best reception is
obtained.
Adjust the oval antenna
until the best reception is obtained.
Switching On and Regulating the Amplifier
You can regulate the amplifier gain by turning the
regulator 4 on the front of the appliance:
7 Switch on the indoor antenna by turning the
regulator
indicator
Turn the regulator
increase the amplifier gain.
Turn the regulator
to decrease the amplifier gain.
Turn the regulator
until it clicks to switch off the indoor antenna.
- 22 -
2 by turning or tilting
4 to the right. The operation
glows green.
3
4 in clockwise direction to
4 in anti-clockwise direction
4 completely to the left
1