Yamaha MT09 Owner's Manual page 32

Instrument and control functions
1
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
2
turn, push this switch to "
leased, the switch returns to the center
3
position. To cancel the turn signal
lights, push the switch in after it has re-
4
turned to the center position.
5
Horn switch " "
Press this switch to sound the horn.
6
Traction control system switch
7
"TCS" (for equipped models)
With the throttle closed, push this
8
switch down to change from TCS "1" to
"2". Push up to change from TCS "2" to
"1".
9
With the vehicle stopped, push this
switch up for two seconds to turn the
10
system off. Push down to turn the sys-
tem on.
11
TIP

The current TCS setting is shown
12
in the TCS display (page 3-10).

See page 3-21 for an explanation
EAU12461 of the traction control system and
/ "
the TCS settings.
". When re-
Stop/Run/Start switch "
To crank the engine with the starter, set
this switch to "
switch down towards " ". See page
5-2 for starting instructions prior to
starting the engine.
EAU12501
Set this switch to "
in case of an emergency, such as when
the vehicle overturns or when the throt-
tle cable is stuck.
EAU73441
The engine trouble warning light will
come on when the key is turned to "ON"
and the start switch is pushed, but this
does not indicate a malfunction.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
EAU54212 NOTICE
/ / "
Do not use the hazard lights for an
extended length of time with the en-
", and then push the
gine not running, otherwise the bat-
tery may discharge.
" to stop the engine
Drive mode switch "MODE"
Do not change the D-mode while the
vehicle is moving.
EAU41701
Using this switch changes the drive
mode to "STD", "A", or "B" in the follow-
ing order:
STD  A  B  STD
The throttle grip must be completely
closed in order to change the drive
EAU12735
mode. (See page 3-15 for an explana-
" posi-
tion of each drive mode.)
TIP

3-17
WARNING
The mode is set to "STD" by de-
fault. The mode resets to "STD"
when the key is turned to "OFF".
ECA10062
EAU47496
EWA15341