Throttle Lever - Yamaha YFM700RA Owner's Manual

EBU18080
Engine stop switch "
Set this switch to "
The engine stop switch controls the ignition and
stops the engine when it is running. Use this switch
to stop the engine in an emergency situation. The
engine will not start or run when this switch is set
to " ".
4
EBU18101
Start switch " "
Push this switch to crank the engine with the start-
er. See the starting instructions on page 6-1 prior
to starting the engine.
EBU18152
Light switch "
Set this switch to "
and the taillight. Set the switch to "
the high beams and the taillight. Set the switch to
"OFF" to turn off all the lights.
ECB00041
NOTICE
Do not use the headlights with the engine
turned off for an extended period of time, oth-
erwise the battery may discharge to the point
that the starter motor will not operate properly.
/ "
" before starting the engine.
/ /OFF"
" to turn on the low beams
" to turn on
If this should happen, remove the battery and
recharge it. See page 8-43 for battery charging
information.
EBU18282

Throttle lever

Once the engine is running, pushing the throttle le-
ver will increase the engine speed.
Regulate the speed of the ATV by varying the
throttle position. Because the throttle is spring-
loaded, the ATV will decelerate, and the engine will
return to an idle any time the throttle lever is re-
leased.
1. Throttle lever
4-6
1