Yamaha YFM700RA Owner's Manual page 30

G
two tripmeters (which show the distance trav-
eled since they were last set to zero)
G a clock
G an hour meter (which shows the total time the
engine has been running)
G
a self-diagnosis device
Odometer and tripmeter modes
4
Pushing the "SELECT" button switches the display
between the odometer mode "ODO" and the trip-
meter modes "A" and "B" in the following order:
ODO → A → B → ODO
To reset a tripmeter, select it by pushing the "SE-
LECT" button, and then push the "RESET" button
for at least three seconds. The tripmeters can be
used to estimate the distance that can be traveled
with a full tank of fuel. This information will enable
you to plan future fuel stops.
TIP
Pushing and holding in the "SELECT" button, and
turning the key to "ON" while the button is pushed,
switches the display between "mph" and "km/h".
Clock mode
Push and hold "SELECT" button for at least three
seconds to switch the display between the clock
mode "CLOCK" and the hour meter mode "HOUR"
in the following order:
CLOCK → HOUR → CLOCK
To set the clock
1. Set the display to the clock mode.
2. Push the "SELECT" button and "RESET" but-
ton together for at least three seconds.
3. When the hour digits start flashing, push the
"RESET" button to set the hours.
4. Push the "SELECT" button, and the minute
digits will start flashing.
5. Push the "RESET" button to set the minutes.
6. Push the "SELECT" button and then release it
to start the clock.
4-4