Yamaha YFM700RA Owner's Manual page 118

TIP
To check the rear brake fluid level, remove the
seat. (See page 4-13.)
To access the rear brake fluid reservoir for replen-
ishing:
1. Remove the cowling bolt and quick fastener
screw.
8
1. Quick fastener screw
2. Bolt
2. Pull the cowling slightly outward as shown.
1
2
1. Cowling
2. Brake fluid reservoir cap
3. After replenishing, place the cowling in the
original position, and then install the bolt and
quick fastener screw.
Observe these precautions:
G
When checking the fluid level, make sure that
the top of the brake fluid reservoir is level.
G
Use only the recommended quality brake fluid,
otherwise the rubber seals may deteriorate,
causing leakage and poor braking performance.
Recommended brake fluid:
DOT 4
8-31
1
2