Setting The Cutting Height; Gb Mt; Emptying The Grass Collection Box; Mowing With The Mulch Kit - FLORABEST FBM 190 A1 Translation Of Original Operation Manual

GB MT
• On slopes, always work across the
slope.
• If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
stationary and check the equipment
for damage. Restart work only if the
equipment is undamaged.
• Switch off the equipment during long-
er breaks and for transportation and
wait until the blade is stationary.
• Clean the equipment after each use,
as described in the "cleaning and
maintenance" chapter.

Setting the Cutting Height

The equipment has 7 positions for setting
the cutting height (30-70 mm):
1. Pull the lever (18) outwards and
push it to the desired position
1-7 (33).
2. Push the lever (18) back in.
The correct cutting height is around
30 – 45 mm for an ornamental lawn and
around 40 – 65 mm for a utility lawn.
Select a greater cutting height for
the first cut of the season.
Emptying the Grass Collection
Box
Through the observation window
fitted in the rear impact protection
( 7), you will see when the grass
collection box is full.
1. Stop the engine and wait until
the blade is stationary.
2. Lift the rear impact protection
68
(7) and remove the grass collec-
tion box (20).
3. Empty (see "disposal / environ-
mental protection" chapter) and
reassemble the grass collection
box (20).

Mowing with the Mulch Kit

When mulch mowing, the grass is cut,
chaffed and spread on the lawn all in one
go. The cut grass serves as a natural fer-
tiliser.
Tips for Mulch Mowing:
• Cut the grass back by 2 cm from a
grass height of 4-6 cm.
• Use sharp cutting blades.
• Do not mow wet grass.

Tool Compartment

To open the tool compartment (
push the red locking button upwards and
the compartment can be opened.

Cleaning and Maintenance

Have any repair and mainte-
nance work not described in
these instructions carried out by
a specialist workshop. Use only
original Grizzly replacement
parts. Risk of accidents!
Carry out maintenance and
cleaning work strictly with the
engine switched off and spark
plug connectors removed. Risk
of injury!
Allow the equipment to cool
before any maintenance and
cleaning work. Elements of the
engine are hot. Risk of burning!
25)