Model Tech SE5a SCOUT Instructions For Final Assembly page 35

STEP 1: INSTALLING THE WINDSCREEN & HEADREST FAIRING
STEP 2: INSTALLING THE EXHAUST FAIRINGS
Using a pair of scissors, carefully cut out each exhaust fairing along its molded base, leaving about 1/8" of material to
use as a gluing surface. Use 220 grit sandpaper with a sanding block to sand the edges smooth and straight.
Using a pair of scissors, carefully cut out the windscreen
along the molded scribe lines.
Using 220 grit sandpaper with a sanding block, carefully
sand the edges of the windscreen smooth and straight.
Using a pair of scissors, carefully cut out the headrest along
its molded base, leaving about 1/8" of material to use as a
gluing surface.
Using 220 grit sandpaper with a sanding block, carefully
sand the edges of the headrest smooth and straight.
Carefully glue the windscreen and headrest to the fuselage,
using a thin layer of Formula 560 canopy glue. Remove any
excess glue, using a paper towel and water, and hold the parts
in place, using pieces of masking tape, until the glue completely
cures.
IMPORTANT Do not use C/A to glue the parts into place.
The C/A (unless plastic-safe) will fog up the plastic parts.
Carefully glue one exhaust fairing onto each side of the
cowling, using a thin layer of Formula 560 canopy glue.
Remove any excess glue, using a paper towel and water, and
hold the exhaust fairings in place, using pieces of masking tape,
until the glue completely cures.
35
Continued On Next Page