Controls; Engine Shut-Off Cord (Lanyard); Engine Oil - Yamaha F100D Owner's Manual

Operation
EMU36903

Controls

Tiller handle models:
 Move the tiller handle fully to the left and
right to make sure operation is smooth.
 Turn the throttle grip from the fully closed
to the fully open position. Make sure that it
turns smoothly and that it completely re-
turns to the fully closed position.
 Look for loose or damaged connections of
the throttle and shift cables.
Remote control models:
 Turn the steering wheel full-right and full-
left. Make sure operation is smooth and un-
restricted throughout the whole range with
no binding or excessive free play.
 Operate the throttle levers several times to
make sure there is no hesitation in their
travel. Operation should be smooth over
the complete range of motion, and each le-
ver should return completely to the idle po-
sition.
 Look for loose or damaged connections of
the throttle and shift cables.
EMU36484

Engine shut-off cord (lanyard)

Inspect the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
1. Clip
2. Engine shut-off cord (lanyard)
44
1
2
ZMU06873
EMU40994

Engine oil

1. Place the outboard motor in a vertical
position (not tilted). NOTICE: If the out-
board motor is not level, the oil level
indicated on the oil dipstick may not
be accurate.
[ECM01862]
2. Remove the oil dipstick and wipe it
clean.
1. Oil dipstick
3. Insert the oil dipstick completely and re-
move it again.
4. Check that the oil level on the oil dipstick
is between the upper and lower marks.
Consult your Yamaha dealer if the oil lev-
el is not at the proper level or if it appears
milky or dirty.
1. Lower mark
2. Oil dipstick
3. Upper mark
1
ZMU05368