Handlebar Switches - Yamaha WOLVERINE 350 YFM25XX Owner's Manual

EBU18061

Handlebar switches

4
1. Light switch " /
2. Engine stop switch "
3. Start switch " "
EBU18080
Engine stop switch "
Set this switch to "
The engine stop switch controls the ignition and
stops the engine when it is running. Use this switch
to stop the engine in an emergency situation. The
engine will not start or run when this switch is set
to " ".
/OFF"
/ "
/ "
" before starting the engine.
EBU18100
Start switch " "
Push this switch to crank the engine with the start-
er.
ECB00050
CAUTION:
See the starting instructions on page 6-1 prior
to starting the engine.
EBU18151
Light switch "
Set this switch to "
and the taillight. Set the switch to "
the high beams and the taillight. Set the switch to
"OFF" to turn off all the lights.
ECB00040
CAUTION:
Do not use the headlights with the engine
turned off for an extended period of time, oth-
erwise the battery may discharge to the point
that the starter motor will not operate properly.
If this should happen, remove the battery and
recharge it.
4-3
/ /OFF"
" to turn on the low beams
" to turn on