Adjusting Dial-A-Height; Adjusting Anti-Scalp Wheels - Toro 78281 Operator's Manual

2
3
Figure 19
1. Key
2. Lift switch UP

Adjusting Dial-A-Height

The Dial-A-Height control (Fig. 18) is used to limit the
downward travel of the attachment. The Dial-A-Height
knob is rotated to change the location of this stop, up or
down.
1. Raise the attachment lift lever: Refer to Raising
Attachments. In the raised, position the Dial-A-Height
knob (Fig. 18) can be rotated to change the stop
location. Turn clockwise to raise and counterclockwise
to lower the height of the attachment.
2. The Dial-A-Height indicator (Fig. 18) will show the
change, high to low, in attachment lift height as
adjustment is made.

Adjusting Anti-Scalp Wheels

The anti-scalp wheels must be adjusted in the proper hole
location for each height-of-cut position.
1. After adjusting height-of-cut. raise the attachment lift
lever: Refer to Raising Attachments.
2. Remove hairpin cotter and pin to change hole location
(Fig. 20).
3. Select a hole position so the anti-scalp wheel is 3/8"
(9.5 mm) off the ground for the height-of-cut to be used
(Fig. 20).
4. Insert pin and secure with hairpin cotter.
5. Repeat adjustment on other anti-scalp wheels.
1
2266
3. Lift switch DOWN
12
3
1
Figure 20
1. Wheel
2. Pin
2
1233
3. Hair pin Cotter