Adjusting Dial-A-Height; Adjusting Anti-Scalp Rollers - Toro 78268 Operator's Manual

Adjusting Dial-A-Height

The Dial-A-Height control (Fig. 15) is used to limit
the downward travel of the attachment. The
Dial-A-Height knob is rotated to change the location
of this stop, up or down.
1. Raise the attachment lift lever: Refer to Raising
Attachments. In the raised, position the
Dial-A-Height knob (Fig. 15) can be rotated to
change the stop location. Turn clockwise to raise
and counterclockwise to lower the height of the
attachment.
2. The Dial-A-Height indicator (Fig. 15) will show
the change, high to low, in attachment lift height
as adjustment is made.

Adjusting Anti-Scalp Rollers

The anti-scalp rollers guide the mower over uneven
turf without scalping the lawn. For most cutting
conditions they should be located in the lower hole.
When cutting in 1-1/2" (38 mm) height-of-cut or
lower move the anti-scalp rollers to the upper hole
position.
1. Raise the attachment lift lever: Refer to Raising
Attachments.
2. Remove cotter pin, bolt and shaft to change hole
location (Fig. 17).
3. Select the hole position for the height-of-cut to
be used and insert rod (Fig. 17).
4. Secure rod with bolt and cotter pin.
3
4
1
Figure 17
1. Roller
2. Cotter pin
3. Bolt
Operation
5
6
2
m–1220
4. Rod
5. Upper hole
6. Lower hole
13