Attachment Power Lift; Adjusting Dial-A-Height; Positioning The Seat - Toro 72116 Operator's Manual

Attachment Power Lift

The attachment power lift (Fig. 11) is used to raise
and lower attachments.
Raising Attachments
1. Turn key to the "ON" or "RUN" position
(Fig. 11).
2. Push the lift switch in the "UP" direction to raise
the attachment lift (Fig. 11). This will lift and
hold the attachment in the up, or raised position.
Lowering Attachments
1. Turn key to the "ON" or "RUN" position
(Fig. 11).
2. Push the lift switch in the "DOWN" direction to
lower the attachment lift (Fig. 11). This will
lower the attachment lift.
2
3
Figure 11
1. Key
2. Lift switch UP
3. Lift switch DOWN
1
4
5
2266
4. Dial-A-Height knob
5. Dial-A-Height indicator

Adjusting Dial-A-Height

The Dial-A-Height control (Fig. 11) is used to limit
the downward travel of the attachment. The
Dial-A-Height knob is rotated to change the location
of this stop, up or down.
1. Raise the attachment lift lever: Refer to Raising
Attachments. In the raised position the
Dial-A-Height knob (Fig. 11) can be rotated to
change the stop location. Turn clockwise to raise
and counterclockwise to lower the height of the
attachment.
2. The Dial-A-Height indicator (Fig. 11) will show
the change, high to low, in attachment lift height
as adjustment is made.

Positioning the Seat

The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable.
1. Raise the seat and loosen the adjustment knobs
(Fig. 12).
2. Slide the seat to the desired position and tighten
the knobs.
1
Figure 12
1. Adjustment knob
Operation
19