Adjusting Dial-A-Height; Adjusting Anti-Scalp Rollers - Toro 78231 Operator's Manual

Adjusting Dial-A-Height

The Dial-A-Height control (Fig. 16) is used to limit the
downward travel of the attachment. The Dial-A-Height
knob is rotated to change the location of this stop, up or
down.
1. Raise the attachment lift lever: Refer to Raising
Attachments. In the raised, position the Dial-A-Height
knob (Fig. 16) can be rotated to change the stop
location. Turn clockwise to raise and counterclockwise
to lower the height of the attachment.
2. The Dial-A-Height indicator (Fig. 16) will show the
change, high to low, in attachment lift height as
adjustment is made.

Adjusting Anti-Scalp Rollers

The anti-scalp rollers guide the mower over uneven turf
without scalping the lawn. For most cutting conditions
they should be located in the lower hole. When cutting in
1-1/2" height-of-cut or lower move the anti-scalp rollers
to the upper hole position.
1. Raise the attachment lift lever; refer to Raising
Attachments.
2. Remove cotter pin, bolt and shaft to change hole
location (Fig. 18).
3. Select the hole position for the height-of-cut to be used
and insert rod (Fig. 18).
4. Secure rod with bolt and cotter pin.
3
4
1
Figure 18
1. Roller
2. Cotter pin
3. Bolt
Operation
5
6
2
1220
4. Rod
5. Upper hole
6. Lower hole
13