Adjusting Dial-A-Height; Adjusting Center Anti-Scalp Roller - Toro 78261 Operator's Manual

Adjusting Dial-A-Height

The Dial-A-Height control (Fig. 16) is used to limit
the downward travel of the attachment. The
Dial-A-Height knob is rotated to change the location
of this stop, up or down.
1. Raise the attachment lift lever: Refer to Raising
Attachments. In the raised, position the
Dial-A-Height knob (Fig. 16) can be rotated to
change the stop location. Turn clockwise to raise
and counterclockwise to lower the height of the
attachment.
2. The Dial-A-Height indicator (Fig. 16) will show
the change, high to low, in attachment lift height
as adjustment is made.
Adjusting Center Anti-Scalp
Roller
The anti-scalp roller helps guide the mower over
uneven turf without scalping the lawn. For most
cutting conditions this roller should be set in the
lower hole (Fig. 18). When cutting in 1-1/2"
height-of-cut or lower move the anti-scalp roller to
the upper hole position.
1. Raise the attachment lift lever; refer to Raising
Attachments.
2. Remove cotter pin, bolt and shaft to change hole
location (Fig. 18).
3. Select the hole position for the height-of-cut to
be used and insert rod (Fig. 18).
4. Secure rod with bolt and cotter pin.
3
4
1
Figure 18
1. Roller
2. Cotter pin
3. Bolt
Operation
5
6
2
1220
4. Rod
5. Upper hole
6. Lower hole
13