Specifications - Toro 4130 Operator's Manual

Specifications

Engine: 3.7 horsepower (2.7 kw) engine with 2.64
quarts (2.5 l) capacity gas tank.
7/8 in.(22 cm) diameter, 17-gauge welded
Handle:
steel tubing with formed steel reinforcement panel.
Traction Unit: Cast aluminum housing.
Cast aluminum and zinc side plates, alu-
Reel Unit:
minum extrusion back plate. Reel unit independent
of traction unit and catcher.
Front Rollers: 2 in. (51 mm) O.D. Steel tube with
ball bearings, moisture excluding oil seals and
replaceable wear sleeves.
1/8 to 11/16 in. (3 to 17 mm).
Height Of Cut:
(Optional micro-cut bedknife 6mm to 24)
Width Of Cut: 21 in. (0.53 m).
: 0.197 in. (5.0 mm).
Clip
2.1 mph (3.4 Km/hr) at 1600 RPM
Ground Speed:
and 4.0 mph (6.4 Km/hr.) at 3100 RPM.
"A" section "V" belt on 2.0 pitch
Traction Drive:
diameter and 3.70 pitch diameter. to countershaft (1.
85:1) 18T and 48T gear 2.67:1 and 20T and 56T
gear (2. 8:1). All gears 16 pitch, 20° involute full
depth, 1/2 in. (13 mm) wide. Gears running in oil.
Reduction, Engine to Traction Drum:
6 in. (15.2 cm) diameter solid rub-
Traction Drum:
ber on 16 gauge (1.5 mm) steel rims. Two sections
running on ball bearings.
Traction Drive Clutch:
operated latch and bail at handle.
Enclosed spur gears.
Differential:
Reel Drive: "A" section V-belt on 2.0 RD. and 3.70
RD. to countershaft (1. 85:1) 3/8 in. pitch x 3/16 in.
wide chain on 20T and 14T sprockets from counter-
8
13.86:1.
Friction Disk type—Hand
shaft. Reduction Engine to Reel—1.30:1.
Engaging jaw type—hand operated at
Reel Clutch:
the transaxle.
3-1/2 in. (89 mm) diameter 9-blade, welded
Reel:
tubular construction. Reel blades, high carbon heat
treated steel. Reel bearings, taper roller with adjust-
ment.
Single-edge high carbon steel
Bedknife and Bar:
knife, extra hard for long life, screwed to extruded
aluminum one-piece bed bar and back plate.
Dimensions:
Width: 27 in. (0.69 m)
Height: 44-3/4 in. (1.1 m) with handle
Length: 60 in. (1.5 m) including handle and catcher
Weight: 69 kilograms with catcher and cutting unit.
Optional Equipment:
Cutting Unit
Brush Kit
Skid Kit,
Sectional Roller Kit
Urethane Comb Kit
Full Roller Kit
Micro-cut Bedknife
Model 04216
Part No. 2-2949
Part No. 4-7299
Part No. 4-7319
Part No. 8-2560
Part No. 4-7309
Part No. 95-3147