Toro 4130 Operator's Manual page 13

2. Measure the distance between the lip of the
catcher and the edge of the cutting unit shield.
There should be a clearance between the com-
ponents of no more than 1/4 inch (6 mm) (Fig.
14). If not, adjust the catcher.
The catcher should be lower in front to
Note:
assist clipping throw. Adjust the screw to lower
the catcher (Fig. 13). Make sure the catcher
clears the roller by at least 1/16 in. (1.6 mm).
3. Tighten the jam nuts on each side of the catcher
(Fig. 13), making sure the dimension is equal
on both sides of the unit.
Figure 14
1. 1/4 inch (6 mm) maximum
1
Before Operating
13