Toro 4130 Operator's Manual page 12

Before Operating
1
Figure 10
1. Scraper rod
2. Bracket
CHECK CUTTING UNIT
ALIGNMENT
The cutting unit must be in alignment with the front
yoke roller so that the machine will track in a
straight line across the greens. Also, the driveshaft
must also be aligned with the transaxle shaft.
Alignment procedures:
1. Loosen the jam nut securing the ball sockets to
the pull arms on both sides of the yoke
(Fig. 11).
2. Slide back the sleeves on each ball joint and
rotate each pull arm upward off the ball studs.
3. Align the cutting unit with the roller and drive-
shaft with the transaxle shaft and lengthen or
shorten the pull rods by threading the ball sock-
et on the rod (Fig. 11).
4. Align the ball sockets with the ball studs so the
hooded portion of the socket is at the top and
the open side is toward the stud (Fig. 12).
5. Slide the sleeve back on the ball joint and rotate the pull
arm down so the socket fits over the ball stud. Release the
sleeve so it slides forward over the stud and locks the
assemblies together. Tighten the jam nuts to secure the
sockets in position (Fig. 15).
12
1
1. Jam nut
2. Ball socket
3. Ball stud
5
1. Spring
2. Sleeve
3. Socket ball joint receiver
4. Retaining ring
4. Ball Stud
INSTALL THE GRASS CATCHER
1. Set the studs on the catcher pivots into the
brackets on the yoke and allow the catcher
adjusting screw to rest onto the yoke (Fig. 13).
1. Catcher pivot
2. Yoke bracket
3. Adjusting screw
4. Jam nut
Figure 11
1
2
3
Figure 12
2
1
4
3
Figure 13
4