Operating Controls - Toro 4130 Operator's Manual

Operating

OPERATING CONTROLS

To operate the controls for mowing;
1. Start the engine, push down on the handle to
elevate the cutting unit, raise the traction clutch
bail the handle and transport the machine onto
the collar of the green.
2. Release the traction clutch bail (Fig. 19) to the
DISENGAGE position and pull the reel drive
control knob on the transaxle out fully to
ENGAGE the reel (Fig. 20).
1
Figure 19
1. Traction clutch control bail
1
Figure 20
1. Reel drive control knob—Pull out to ENGAGE
3. Raise the clutch control bail to the handle,
increase the throttle speed until the unit is trav-
eling at the desired ground speed, drive the
mower out onto the greens area, drop the front
of the mower down and begin mowing.
AFTER MOWING
1. Drive off the green, release the clutch control
bail to DISENGAGE, stop the engine and push
the reel drive control knob fully in to DISEN-
GAGE.
16
2. Empty the grass catcher of clippings, install the
grass catcher and begin transport operation;
refer to Transport Operation.