Controls - Toro 4130 Operator's Manual

Controls

Throttle Control Lever
connects to and operates the throttle linkage to the
carburetor. It has two positions: SLOW and FAST.
Engine speed can be varied between the two settings.
2
Figure 15
1. Throttle control lever
2. Clutch control bail
Clutch Control Bail (Fig. 15)—The clutch bail con-
trols traction and cutting unit drive. It has two posi-
tions: ENGAGE and DISENGAGE.
Choke Lever (Fig. 16)—Located at rear of engine.
It has two positions: RUN and CHOKE. Move the
lever to the CHOKE position when starting a cold
engine. After engine start,s move the lever to the
RUN position.
2
Figure 16
1. Fuel shut-off valve lever
2. Choke lever
(Fig. 16)—Located at the right
Fuel Shut-off Valve
side of the engine, it has two positions: CLOSED
and OPEN. Move the valve lever to the CLOSED
position when storing the machine. Open the valve
before starting the engine.
14
(Fig. 15)—The throttle lever
1
1
2
1
Figure 17
1. Engine stop switch
2. Recoil starter
(Fig. 17)—Located at the front
Engine Stop Switch
of the engine. Rotate to OFF to stop the engine.
Recoil Starter (Fig. 17)—Pull the recoil starter han-
dle to start the engine.
Reel Drive Control (Fig. 18)—Located at right side
transaxle, has two positions: ENGAGE and DISEN-
GAGE. Pull out the knob to engage the reel drive
clutch. Push in the knob to disengage.
1
Figure 18
1. Reel drive control knob—Pull out to ENGAGE