Table of Contents
Advertisement
Adjusting the Lift Springs
The lift springs can be adjusted to control the amount of
power it takes to lift the snowthrower and the downward
force the snowthrower has while traveling over the ground.
If you change the downward snowthrower force, it will
directly affect the power needed to lift the snowthrower.
1. To increase the downward force, which will make it
harder to lift the snowthrower, loosen the 2 eyebolts and
nuts attached to the lift springs (Fig. 27).
2. To make it easier to lift the snowthrower, which will
decrease the downward force, tighten the 2 eyebolts and
nuts attached to the lift springs (Fig. 27).
1
3
2
Figure 27
1. Lift spring
2. Lift tube
4
M–7081
3. Eyebolt
4. Nut
15
Operation
Note: Determine the left and right sides of the machine
from the normal operating position.
Operating the
Power Take Off (PTO)
The power take off (PTO) switch engages and disengages
power to the electric clutch.
The PTO light, in the Indicator Module, will be on when
the ignition key is in run or the lights position and the
power take off (PTO) is engaged. When this light is on, it is
a reminder the starter will not crank and to turn the off PTO
before getting off the tractor.
Engaging the Power Take Off (PTO)
1. Move the throttle to the fast position.
2. Pull the power take off (PTO) to the on position
(Fig. 28).
1
Figure 28
1. PTO—Off
Disengaging the Power Take Off (PTO)
1. Push the power take off (PTO) to the off position
(Fig. 28).
Using the Attachment Power
Lift
The attachment power lift (Fig. 29) is used to raise and
lower attachments.
Raising Attachments
1. Turn key to the on or run position (Fig. 29).
2. Push the lift switch in the up direction to raise the
attachment lift (Fig. 29). This will lift and hold the
attachment in the up, or raised position.
2
m–6524
2. PTO—On
Advertisement
Table of Contents
