Installing The Belt And Belt Spring - Toro 79482 Operator's Manual

2
6
4
1
m–7123
Figure 20
1. Tension spring lever
2. Crank support rod
3. J–pin
4. Tension spring arm
Installing the Belt and Belt
Spring
1. Raise the snowthrower up into the transport position.
See the Operation Section for raising the snowthrower.
2. Hook one end of the belt spring onto the snowthrower
frame (Fig. 21).
3. Route the belt around the clutch pulley and the
snowthrower pulleys (Fig. 21 and 22).
4. Hook the other end of the spring into the belt idler arm
hook (Fig. 21).
5
3
5. Snowthrower pulley box
6. Idler pulley bracket
handle
13
1
4
Figure 21
1. Belt spring
2. Idler arm hook
2
1
Figure 22
1. Belt
5. Align the hood onto the pivot pegs and slide the hood to
the right side of the machine (Fig. 23).
2
3
m–7082
3. Snowthrower frame
4. Belt
m–7073
2. Tractor clutch