Table of Contents
Advertisement
Lowering Attachments
1. Turn key to the on or run position (Fig. 29).
2. Push the lift switch in the down direction to lower the
attachment lift (Fig. 29). This will lower the attachment
lift.
2
3
Figure 29
1. Key
2. Lift switch —up
Operating the Attachment Lift
Lever
The attachment lift lever (Fig. 30) is used to raise and lower
various attachments.
Raising an Attachment
1. Depress the brake pedal to stop the machine.
2. Pull the attachment lift lever rearward until the latch
locks. In this position the lift will hold the attachment in
the up, or raised position.
Lowering an Attachment
1. Depress the brake pedal to stop the machine.
1
m–6513
3. Lift switch —down
16
2. Pull the attachment lift lever rearward, to release the lift
pressure, and push the button on top to release the latch.
Move the lift lever forward to lower the attachment.
2
1
Figure 30
1. Lift lever
Adjusting the Discharge Chute
Danger
When the snowthrower is in operation, the
impeller and auger can be rotating and cut off or
injure hands and feet.
Before adjusting, cleaning, repairing and
inspecting the snowthrower, and before
unclogging the discharge chute, disengage the
PTO, stop the engine, remove the key, and wait
for all moving parts to stop.
Use a stick, not your hands, to remove an
obstruction from the discharge chute.
Stay away from the discharge and auger
openings while operating the snowthrower.
Keep face, hands, feet, and any other part of
your body or clothing away from concealed,
moving, or rotating parts.
You can rotate the discharge chute 180 degrees side to side
by turning the crank handle (Fig. 31).
m–6531
2. Button
Advertisement
Table of Contents
