Identification And Ordering - Toro 08882 Operator's Manual

brush dipped in ammonia or bicarbonate of soda solution.
Flush the top surface with water after cleaning. Do not remove
the fill cap while cleaning.
3. Battery cables must be tight on terminals to provide good elec-
trical contact.
4. If corrosion occurs at the terminals, disconnect the cables, neg-
ative (–) cable first and scrape clamps and terminals separately.
Reconnect cables, positive (+) cable first and coat terminals
with petroleum jelly.
5. Check the electrolyte level every 25 operating hours or, if the
machine is in storage, every 30 days.
6. Maintain cell level with distilled or demineralized water. Do
not fill cells above the fill line.

IDENTIFICATION AND ORDERING

MODEL AND SERIAL NUMBERS
The SAND PRO 2000 has two identification numbers: a model
number and a serial number. These numbers are stamped into a
plate located on left fender. In any correspondence concerning the
unit, supply the model and serial numbers to ensure correct infor-
mation and replacement parts are obtained.
Note: Do not order by reference number if a parts catalog is being
used; use the part number.
To order replacement parts from an authorized TORO Distributor,
supply the following information:
1. Model and serial numbers.
2. Part number, description, and quantity of parts desired.
21