Toro 71221 Operator's Manual page 40

Maintenance
5. Install the mower pivot mount brackets to the
front axle with bolts and lock nuts (Fig. 42).
3
Figure 42
1. Pivot mount bracket
2. Bolt 5/16–18 x 2-1/2"
6. Move the height-of-cut lever (deck lift) into the
"A" notch.
7. Slide the end of the long rod through the hole in
the mower mount (Fig. 43). Install the washer
and hair pin cotter to secure the rod in place.
Repeat this step on the opposite side of the
mower.
8. Mount the slotted mower leveling bracket onto
the pin on the height-of-cut arm (Fig. 43). Install
the washer and hair pin cotter to secure the
mower. Repeat this step on the opposite side of
the mower.
38
2
1
m–4187
3. Lock nut
2
4
Figure 43
1. Hairpin cotter and washer
2. Long rod
9. Look under tractor and take down blade control
(PTO) cable nested inside frame rail.
10. Remove first jam nut and thread second jam nut
onto the blade control (PTO) cable all the way.
Route cable through slot in deck bracket and
thread second jam nut onto cable (Fig. 44).
11. Hook end of blade control (PTO) cable onto
idler spring (Fig. 44).
1
1 3
1805
3. Leveling bracket
4. Mower mount