Greasing And Lubrication; Tire Pressure - Toro 71221 Operator's Manual

Greasing and Lubrication

Service Interval/Specification
Grease the machine after every 25 operating hours or
once a year, whichever occurs first. Grease more
frequently when operating conditions are extremely
dusty or sandy.
Grease Type: General-purpose grease.
How to Grease
1. Disengage the blade control (PTO), set the
parking brake, and turn the ignition key to
"OFF" to stop the engine.
2. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
3. Connect a grease gun to the fitting. Pump grease
into the fittings.
4. Wipe up any excess grease.
Where to Add Grease
1. Lubricate the front wheels until grease begins to
ooze out the bearings (Fig. 14).
Figure 14

Tire Pressure

Service Interval/Specification
Maintain the air pressure in the front and rear tires as
specified. Check the pressure at the valve stem after
every 25 operating hours or yearly, whichever occurs
first (Fig. 15). Check the tires when they are cold to
get the most accurate pressure reading.
Set pressure to 12 psi (83 kPa) front and
rear for tractors with serial numbers
9905000 and prior.
Set pressure to 20 psi (138 kPa) (tires with
markings of "Kenda", "Super Turf") for
tractors with serial numbers 9905001 and
up.
Maintenance
2346
21