Form No. 3324-822 Rev A 17-44HXLE Wheel Horse Lawn Tractor Model No. 71282—Serial No. 210000001 and Up Model No. 71283—Serial No. 210010001 and Up Setup Instructions Loose Parts Note: Use the chart below to verify that all parts have been shipped.
Installing the Front Wheels Note: If the wheels are already installed, refer to Checking the Tire Pressure (below). 1. Install the shim washers onto the axle. 2. Install the wheel onto the axle with the valve stem facing out. 3. Slide the flat washer onto the axle. Insert the cotter pin through the axle and bend the ends of the pin apart (Fig.
Installing the Seat Activating the Battery Note: If the seat is already installed, proceed to Activating Warning the Battery, page 3. 1. Insert the seat switch wire cable through the hole in the Battery posts, terminals, and related accessories seat base (Fig. 4). contain lead and lead compounds, chemicals 2.
3. Wait five to ten minutes after filling the battery cells. Checking the Oil Level Add electrolyte, if necessary, until the electrolyte level is up to the Upper line (Fig. 5) on the battery case. The tractor is shipped from the factory with oil in the engine crankcase;...
Checking the Hydro Neutral Position Ensure that the neutral position is set properly. An adjustment is required if the tractor moves without the traction control pedal being depressed. 1. Run the engine at a low idle and move the traction control pedal forward, then release.