Servicing The Spark Plug - Toro 38567 Operator's Manual

9. Screw the oil fill cap into the oil fill hole, and hand
tighten it securely.
10. Wipe up any spilled oil.
11. Dispose of the used oil properly at a local recycling
center.

Servicing the Spark Plug

Service Interval: Yearly—Service the spark plug and
replace it if necessary.
Use a NGK BPR6ES or Champion RN9YC spark
plug or equivalent.
1. Stop the engine and wait for all moving parts to stop.
2. Rotate the discharge chute so that it faces forward.
3. Remove the discharge chute, the discharge chute
handle, and the chute seal by removing the 3 large
screws and one small screw (Figure 33).
Figure 32
1. Fuel tank cap
2. Large screws (3)
3. Discharge chute
4. Remove the 4 screws that secure the shroud
(Figure 34).
1. Screw (4)
2. Shroud
5. Remove the fuel tank cap.
6. Remove the shroud (Figure 34).
7. Install the fuel tank cap.
8. Disconnect the wire from the spark plug.
16
Figure 33
4. Small screw
5. Chute seal
Figure 34
3. Spark plug
4. Spark-plug wire