Natural Gas Conversion - Maytag MGT8720DS Installation Instructions Manual

6. Position the broil burner against the roof of the oven cavity
and attach with screw.
A. Broil burner orifice hood
B. Broil burner
To Convert Surface Burners
1. If the burner grates are installed, remove them.
2. Remove the burner caps.
3. Using a Phillips or TORX
base.
A
B
A. Burner cap
B.Gas tube opening
4. Apply masking tape to the end of a
to help hold the Natural gas orifice spud in the nut driver
while changing it. Press nut driver down onto the Natural gas
orifice spud and remove by turning it counterclockwise and
lifting out. Set the Natural gas orifice spud aside.
A. Natural gas orifice spud
Use the following chart for correct LP gas orifice spud for each
burner. Refer to the model/serial/rating plate behind the control
panel for proper sizing of LP gas orifice spuds for each burner
location.
A
B
screwdriver, remove the burner
®
C
D
C. Burner base screws
D. Burner base
/ " (7.0 mm) nut driver
9
32
A
LP Gas Orifice Spud Chart
Burner Rating Color
4,000 BTU Blue
7,000 BTU Black
9,100 BTU Green
14,000 BTU Red
5. Replace the Natural gas orifice spud with the correct LP gas
orifice spud. See the "LP Gas Orifice Spud Chart."
6. Replace burner base and hand tighten the screws.
7. Replace burner cap.
8. Repeat steps 1 through 7 for the remaining burners.
9. Place Natural gas orifice spuds in plastic parts bag for future
use and keep with literature package.
10. Replace burner grates.
11. Complete installation. See the "Make Gas Connection" and
"Electronic Ignition System" sections.
Checking for proper cooktop burner flame is very important.
The small inner cone should have a very distinct blue flame
/ " to / " long. The outer cone is not as distinct as the inner
1 1
4 2
cone. LP gas flames have a slightly yellow tip.
IMPORTANT: You may have to adjust the LO setting for each
cooktop burner. See "Adjust Flame Height" in the "Electronic
Ignition System" section.

Natural Gas Conversion

WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death
or serious burns to children and adults.
1. Turn manual shut-off valve to the closed position.
A
A. To range
B. Shut-off valve (closed position)
C. Gas supply line
2. Unplug range or disconnect power.
Number
64L
81L
97L
114L
B
C
15