Table of Contents
Advertisement
Available languages
Available languages
In the State of Massachusetts, the following installation instructions apply:
Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
I
the State of Massachusetts.
If using a ball valve, it shall be a T-handle type.
I
A flexible gas connector, when used, must not exceed 3 feet.
I
Anti-Tip
Bracket
Range Foot
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed here.
Tools Needed
Tape measure
■
Phillips screwdriver
■
TORX
T20
screwdriver
®†
®†
■
Flat-blade screwdriver
■
1
/
" flat-blade screwdriver
■
8
Level
■
Hand or electric drill
■
Wrench or pliers
■
Pipe wrench
■
/
" combination wrench
15
■
16
Parts supplied
Check that all parts are included.
LP/Natural Gas Conversion Kit (located on back of range
■
near lower side)
Burner grates
■
Burner caps
■
Oven racks
■
2 - #12 x 1
/
" screws (for mounting anti-tip bracket)
5
■
8
†
TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC.
®
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation instructions.
Slide range back so rear range foot is engaged in the slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed and engaged.
Failure to follow these instructions can result in death or serious burns to children and adults.
To verify the anti-tip bracket is installed and engaged:
• Slide range forward.
• Look for the anti-tip bracket securely attached to floor or wall.
• Slide range back so rear range foot is under anti-tip bracket.
• See installation instructions for details.
INSTALLATION REQUIREMENTS
/
" (3.2 mm) drill bit
1
■
8
Marker or pencil
■
Pipe-joint compound
■
resistant to LP gas
Noncorrosive leak-
■
detection solution
For LP/Natural Gas
Conversions
/
" combination wrench
1
■
2
/
" (7.0 mm) nut driver
9
■
32
Masking tape
■
WARNING
Tip Over Hazard
Anti-tip bracket (taped inside upper oven with literature
■
package)
Anti-tip bracket must be securely mounted to the back wall or
floor. Thickness of flooring may require longer screws to anchor
bracket to subfloor. Longer screws are available from your local
hardware store.
Parts needed
Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See the "Electrical Requirements"
and "Gas Supply Requirements" sections.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances. Do
not obstruct flow of combustion and ventilation air.
It is the installer's responsibility to comply with installation
■
clearances specified on the model/serial/rating number plate.
The model/serial/ rating number plate is located behind the
control panel.
The range should be located for convenient use in the
■
kitchen.
Recessed installations must provide complete enclosure of
■
the sides and rear of the range.
To eliminate the risk of burns or fire by reaching over heated
■
surface units, cabinet storage space located above the
surface units should be avoided. If cabinet storage is to be
provided, the risk can be reduced by installing a range hood
or microwave hood combination that projects horizontally a
minimum of 5" (12.7 cm) beyond the bottom of the cabinets.
All openings in the wall or floor where range is to be installed
■
must be sealed.
3
Advertisement
Table of Contents
