Load Paper - Epson ET-4550 Start Here

5
Carefully seal the bottle using the reverse side of the
bottle tip for proper disposal.
6
Close the ink tank securely.
7
Repeat the previous steps for the 3 other Initial bottles.
8
Close the ink tank unit cover.
9
Connect the power cord to the back of the product and to
an electrical outlet.
Caution: Do not connect to your computer yet.
10
Turn on the product. Select your language, country, date,
and time.
Note:
• You can change these settings later using the product's control
panel. For more information, see the online User's Guide.
• If an error message appears, turn off the product and check
that no protective material has been left inside the product.
11
When the message to see the setup manual is displayed
on the LCD screen, press and hold the OK button for
3 seconds.
12
Press one of the Start buttons to start charging the ink.
Ink charging takes approximately 20 minutes. Ink charging
is complete when the
Note: After some ink is used for charging, the rest is available for
printing.
Caution: Do not turn off the product, raise the scanner unit, or
load paper while the product is charging or you'll waste ink.
3

Load paper

1
Make sure the product is not charging, and then pull out
the paper cassette.
2
Slide the side edge guides all the way out and set the
front edge guide to the paper size you are using.
3
Insert paper with the glossy or printable side down.
Note: Make sure the paper is loaded against the front edge
guide and not sticking out from the end of the cassette.
3 seconds
power light stops flashing.
20 minutes
LTR