Changing The Address Code - Viessmann VITOTROL 100 Operating Instructions Manual

Hide thumbs Also See for VITOTROL 100:

Table of Contents

What to do if...

Changing the batteries

Reset

Changing the address code

Only for the Vitotrol 100, type UTDB-RF if the wireless receiver A flashes.

1. Press Q on the wireless receiver for

approx. 10 s until A flashes.

2. Open the flap of the Vitotrol 100.

3. Press å twice.

4. With v/V select "Settings".

5. Confirm with OK.

6. With v/V select "Service".

7. Confirm twice with OK.

8. With v/V select "Address code".

(cont.)

Press the reset button with a suitable

instrument. After a reset, re-enter the

language, time and date.

9. Confirm with OK.

The display shows a number combi-

nation for approx. 30 s. Then "Send

data" appears on the display. The

transfer takes 30 s. Q flashes during

the transfer.

If the receiver recognises the address

code, Q and A go out. If the address

code is not recognised, repeat the

procedure from point 3 onwards.

Table of Contents