Black & Decker 2755 Instruction Manual page 11

Forward/Reverse Control Button
A forward/reverse control button determines the direction of the tool and
also serves as a "lock off" button. To select forward rotation, release the
trigger switch and depress the forward/reverse control button on the right
side of the tool, as shown in Figure 5a.
To select reverse, depress the forward/reverse control button on the left side
of the tool as shown in Figure 5b. The center position of the control button
locks the tool in the "OFF" position as shown in Figure 5c.
When changing the position of the forward/reverse control button, be sure
the trigger is released.
N N O O T T E E : The first time the tool is run after changing the direction of rotation,
you may hear a click on start up. This is normal and does not indicate a
problem.
DEPRESS FOR FORWARD
F F i i g g u u r r e e 5 5 a a
CENTER POSITION: LOCKED OFF
DEPRESS FOR REVERSE
F F i i g g u u r r e e 5 5 b b
F F i i g g u u r r e e 5 5 c c
Torque Adjustment Collar
Your driver/drill has an adjustable torque screwdriver mechanism for driving
and removing a wide array of fastener shapes and sizes.
Circling the collar are numbers ranging from 0 to 5, and a drill bit symbol.
These numbers (and half numbers designated by dots on the collar) are used
to set the clutch to deliver a torque range.
The higher the number on the collar, the higher the torque and the larger the
fastener which can be driven. To select any of the numbers, rotate until the
desired number aligns with the selector, shown in Figure 6.
TORQUE
ADJUSTMENT
COLLAR
8
F F i i g g u u r r e e 6 6
DUAL RANGE
GEAR SHIFTER
LOW SPEED/HIGH TORQUE
(position 1)
HIGH SPEED/LOW TORQUE
(position 2)