Table of Contents
Advertisement
9.1 BIuetooth pairing
• Make sure that your Bluetooth capable terminal device is
on and Bluetooth is activated.
• Press and hold [pair] to make the radio visible for other
devices. Bluetooth discoverable will appear on the
dipslay.
Press and hold
• Open the Bluetooth settings on your terminal device
and wait until DR1600 appears in the list of Bluetooth
devices found.
• If necessary, start searching for Bluetooth devices on your
terminal device.
• Select DR1600 and wait until the radio is listed as
connected in the Bluetooth settings on your terminal
device.
• Your terminal device is also shown as connected on the
radio display.
• Start and control audio playback using the controls of the
terminal device.
Note – Bluetooth password
Some terminal devices require a password in order to
connect to another Bluetooth device.
• If your terminal device requests a password for
connection to the radio, enter 0000.
9.2 Automatic Bluetooth connection
(after successful pairing)
• Terminal devices already paired with the radio are
automatically saved on the radio.
• If you are pairing the terminal device with the radio for
the first time, proceed as described in 9.1. BIuetooth
pairing.
• Make sure that your Bluetooth capable terminal device is
on and Bluetooth is activated.
• Press [pair] repeatedly until the terminal device you
would like to pair with the radio is shown on the display.
• The devices will be automatically connected.
• If necessary, open the Bluetooth setting on your terminal
device and select DR1600.
• Start and control audio playback using the controls of the
terminal device.
After the radio and terminal device have been paired, a
connection is established automatically. If the Bluetooth
connection is not established automatically, check the
following:
• Check the Bluetooth settings of your terminal device
[pair]
• Check whether your terminal device and the radio are
• Check whether obstacles are impairing the range. If
10. Sleep
The radio has a timer function, which switches the radio to
standby mode after a pre-defined length of time.
• Set the desired length of time (options are
off/15/30/45/60/90 minutes) using [enter/navigate] as
follows:
• After the defined time the radio switches to standby
mode.
• Press [volume /
• If a time interval is already activated, you can change or
disable (Sleep off) it at any time.
12
Note – Connection impaired
to see whether DR1510 is connected. If not, repeat
the steps listed under Bluetooth pairing.
less than 10 metres apart. If not, move them closer
togehter.
so, move the devices closer together.
] , to turn the radio back on.
[menu]
System
Sleep
Advertisement
Table of Contents
