Table of Contents
Advertisement
13. Bluetooth
®
You can pair your terminal device with the radio using
Bluetooth and use it as a playback device. You can control
playback directly on the terminal device. You can adjust
the volume on the radio, as well.
®
Note – Bluetooth
• Check whether your mobile device (smartphone, tablet
PC. etc.) is Bluetooth-capable.
• Note that the maximum range for Bluetooth
10 metres without obstacles such as walls, people, etc.
• The connection may be disrupted by other Bluetooth
devices/connections in the vicinity.
• It is only possible to connect the radio to one terminal
device.
• Note that compatibility depends on the supported
Bluetooth
profiles as well as the Bluetooth
®
being used. (See: Technical data in the operating
instructions for the respective device).
By repeatedly pressing [ ] / [MODE], enable Bluetooth
mode on the radio:
Alternatively, press [BT] on the remote control to switch
directly to this operating mode.
13.1 Bluetooth
pairing
®
• Make sure that your Bluetooth
device is switched on and that Bluetooth
• By repeatedly pressing [ ] / [MODE], enable Bluetooth
mode on the radio:
• Press [ ] (4) to access the Settings menu.
• Use [NAVIGATE/ENTER/VOLUME] (9) to navigate
to the "Setup Bluetooth" menu item.
• Open the Bluetooth
settings on your device and wait until
®
the list of found Bluetooth
• If necessary, start searching for Bluetooth
your device.
• Select DIR90BT and wait until radio is listed as connected
in the Bluetooth
settings of your device.
®
is
®
versions
®
[ ]
capable terminal
®
is activated.
®
[ ]
devices shows DIR90BT.
®
devices on
®
• Your device is also shown as connected on the radio display.
• Start and control audio playback using the controls
on your device.
Note - Bluetooth
Some devices require a password in order to connect
to another Bluetooth
• If your device requests a password to connect to the
loudspeaker, enter 0000.
13.2 Automatic Bluetooth
®
(after successful pairing)
• Devices already paired with the radio are automatically
saved on the radio.
Note - connection impaired
After the radio and terminal device have been paired,
a connection is established automatically. If the Bluetooth
connection is not established automatically, check the
following:
®
• In your device's Bluetooth
is connected. If not, repeat the steps listed under
Bluetooth
pairing.
®
• Check that your device and the radio are less than
10 metres apart. If not, move them closer together.
• Check whether obstacles are impairing the range.
If so, move the devices closer together.
13.3 Terminating the Bluetooth
®
• Then turn [VOLUME/ENTER/NAVIGATE] to select the
YES button and confirm the termination of the Bluetooth
connection by pressing [ENTER/NAVIGATE].
18
®
password
device.
®
connection
®
settings, check that DIR90BT
®
connection
®
[ ]
Main menu
Terminate connection
®
Advertisement
Table of Contents
