Table of Contents
Advertisement
9. Bluetooth
You can pair your terminal device with the radio using
Bluetooth and use it as a playback device. You can control
playback directly on the terminal device. You can adjust the
volume on the radio, as well.
Note – Bluetooth
• Check whether your mobile device (smartphone,
tablet PC. etc.) is Bluetooth-capable.
• Note that the maximum range for Bluetooth is 10
metres without obstacles such as walls, people, etc.
• The Bluetooth connection may be disrupted by other
Bluetooth devices/connections in the vicinity.
• It is only possible to connect the radio to one terminal
device.
• Note that compatibility depends on the supported
Bluetooth profiles as well as the Bluetooth versions
being used. (See: Technical data in the operating
instructions for the respective device)
After pressing [ ]/[ ] repeatedly, activate Bluetooth
operating mode on the radio:
9.1. BIuetooth pairing
• Ensure your Bluetooth-enabled device is switched on and
that Bluetooth is activated.
• Open the Bluetooth settings on your device and wait
until the list of found Bluetooth devices shows DR40BT.
• If necessary, start searching for Bluetooth devices on your
device.
• Select DR40BT and wait until radio is listed as
connected in the Bluetooth settings of your device.
• Your device is also shown as connected on the radio
display.
• Start and control audio playback using the controls on
your device.
[ ] [ ]
7
Note – Bluetooth password
Some terminal devices require a password in order to
connect to another Bluetooth device.
• If your device requests a password to connect to the
radio, enter 0000.
9.2 Automatic Bluetooth connection
(once pairing has been performed)
• Devices already paired with the radio are automatically
saved on the radio.
• If you are pairing the terminal device with the radio for
the first time, proceed as described in 9.1 BIuetooth
pairing.
• Ensure your Bluetooth-enabled device is switched on and
that Bluetooth is activated.
• The connection will be established automatically.
• If necessary, open the Bluetooth settings on your terminal
device and select DR40BT.
• Start and control audio playback using the controls on
your device.
Note - Connection impaired
After the radio and terminal device have been paired, a
connection is established automatically. If the Bluetooth
connection is not established automatically, check the
following:
• In your device's Bluetooth settings, check that
DR40BT is connected. If not, repeat the steps listed
under Bluetooth pairing.
• Check that your device and the radio are less than 10
metres apart. If not, move them closer together.
• Check whether obstacles are impairing the range. If
so, move the devices closer together.
Advertisement
Table of Contents
