Solutions - e-motion STAND UP User Manual

INCIDENCES
1º Alter setting the battery to charge, it
looks like it did not charge.
2º When turning the battery key, the
charge indicator does not light up.
3º The engine suddenly stops after
moving just a few meters or when
climbing a not very steep hill.
4º The engine stops or works irregularly
after having use the vehicle continuously
or on uphill climbs.
5º The battery has not enough autonomy.
6º A strange noise can be hear for the
front wheel (engine)
7º The brakes make noise or/ they do not
brake very well.
17. SOLUTION CHART
POSSIBLE CAUSA
1. The charger is not connected
properly.
2. The charger does not work well.
3. The fuse is out.
1. The battery is discharged on the
whole.
2. The fuse is shorted out or not
connected properly.
3. The key switch does not work.
1. The cable has been detached from
the battery.
2. The fuse is fused.
1. Engine overheated
2. The fuse is fused
3. The battery is discharged.
4. There is an electric malfunction.
1. The battery has not been charged
properly.
2. The battery is not recharging
correctly.
1. The wheel is not aligned properly.
2. The spokes can be loose.
3. The engine gears are worn.
1. the bike is still brand new. It needs a
little running.
2. The brakes are not aligned.
3. The brake levers can not be tightened
properly.
4. The brake shoes are worn.
SOLUTION
1. Adjust the connections to ensure good contact.
Ensure that the battery is in the right position
(ONOFF). Verify the plug.
2. Check the charger light to be on. Contact to the
technical service in case it did not blink.
3. The fuse must be changed.
1. Check the battery indicator and recharge if it
were necessary.
2. Check the fuse and replace if faulty (see the
technical service section)
3. Verify the connections and contact technical
service if faulty.
1. Check to ensure that the battery is connected
properly.
2. Check the fuse and change it if it were
necessary ( see technical section)
1. Intensive and continuous use of the bike at
maximum power may overheat the engine and its
controller. In this case, wait a few minutes to let
2. Check the fuse. See the relevant section.
3. Check the battery charge. The amount
consumed may be different depending on the
4. Check the electric connections. See the
relevant section.
1. The battery has to be in top conditions to
achieve the full charge autonomy established in
this manual. You also have to consider that the
distance you ride will vary depending on the
rider's weight, the trajectory or STAND UP
conditions.
2. Contact to a technical service.
1. Check the alignment of the wheel .
2. Tight the spokes
3. The bearings in models without brushless
engine may wear out. In this case, contact an
authorised dealer to replace them.
1. It is normal in a new bike for brakes to make
some noise. If after a few days of use the, noise
persists, check the brakes to be aligned.
2. Place the brakes in the right position (see the
relevant section)
3. Check the lever tension by means of a
regulator.
4. Check the brake pads and replace them it were
necessary.