Electric Components; Cleaning - e-motion STAND UP User Manual

12.

ELECTRIC COMPONENTS

CONTROLLER
STAND UP controller is the nerve centre of the system. It consists of a small
box placed under the battery compartment and where all the components are
connected.
The controller receives all the necessary information from the brakes, engine,
battery, etc.
The controller is responsible of the engine to work correctly and the STAND UP
safety as well.
The controller checking/handling requires specific tools and know-how. Only an
authorized dealer or the BH plant should manipulate it.
ENGINE
STAND UP is provided with a top-quality, resistant engine. The engine is part of
the front wheel, designed to provide a maximum service with barely any
maintenance. The engine as part of the front wheel must be firmly placed as it is
explained in the section on the wheels section. Otherwise, there is a risk of a
serious problem.
Be especially careful with the engine cable which comes from the front wheel
axle. Do not bend, cut or damage it in any way.
Important: Avoid heavy hits to the front wheel and the rim as well,
since the engine could be damaged.
13.

CLEANING

Clean the vehicle each time after having used the vehicle. Do not delay the
clean since such process can be more difficult once the mud and dirt get dried .
Use a wet piece of cloth with water and soap to clean the vehicle, later take
care to dry all the wet parts, avoiding the electric connections not to get wet.
Do not use strong products which can deteriorate the paint, cables or rubbers.
Verify the kind of product before using it.
Do not wash your STAND UP using a high-pressure water system. The water
could enter into the bearings and other parts deteriorating their effective work
Important to use original pieces
It is extremely important to use always parts when replacing STAND UP
components. Not doing so may invalidate the manufacturer's warranty