Raid Config - Abit NF8 Series User Manual

3-12
OnChip IDE Channel0 / OnChip IDE Channel1:
This item allows you to enable or disable the primary (IDE1) and secondary (IDE2) IDE controller. Select
[Disabled] if you want to add a different hard drive controller.
IDE Prefetch Mode:
Two options are available: Disabled or Enabled. The default setting is Enabled. The onboard IDE drive
interfaces supports IDE prefetching for faster drive accesses. If you install a primary and/or secondary
add-in IDE interface, set this field to Disabled if the interface does not support prefetching.
IDE DMA transfer access:
This item selects the DMA mode for devices connected through IDE channels.
OnChip SATA Controller:
This item enables or disables the on-chip SATA controller.
SATA DMA transfer:
This item selects the DMA mode for devices connected through SATA channels.
#

RAID Config:

Click <Enter> key to enter its submenu:
IDE RAID:
This item allows you to enable or disable the IDE RAID function.
! IDE Channel 0/1 Master/Slave RAID, SATA Primary/Secondary Master RAID:
Select the disks that you want to use as RAID disks.
# Back to Integrated Peripherals Setup Menu:
OnChip USB:
This option enables or disables the USB controller. If you choose to disable this item, the "USB 2.0
Controller" "USB Keyboard Support Via" "USB Mouse Support Via" and "USB Mass Storage
Support" items will not be able to select in Integrated Peripherals menu.
NF8 Series
Chapter 3