Table of Contents
Advertisement
Product Overview
Specifications
Tractors
Height of Cut
Height Of Cut Range
Reel Weldment
Reel Bearings
Power Attachment
Frame
Rollers
Bedknife
Bedknife Adjustment
Grass Shield
Counterweight
Maximum Reel Speed
Weight
These cutting units will mount on the Reelmaster 5510 & 5610 Traction Units.
Cutting height is adjusted on the front roller by two vertical screws and held by two locking
cap screws
Standard bench height of cut range is .250 inch (3 mm) to 1.00 inch (25 mm). Bench height
of cut range with the High Height of Cut Kit installed is 1.00 inch (25 mm) to 2.00 inches
(51 mm). Effective HOC may vary depending on turf conditions, type of bedknife, rollers
and attachments installed.
Reels are 7 inches (18 cm.) in diameter, 22 inches (56 cm.) in length. High strength low
alloy steel blades are thru hardened and impact resistant.
Two double row self-aligning ball bearings, press fit onto reel shaft.
The reel motors feature quick disconnect for removal or installation onto cutting unit. The
cutting units can be driven from either end.
Die cast aluminum cross member with three bolt-on die-cast aluminum side plates.
The front roller is a 3 inch (76 mm) diameter plastic Wiehle roller. The rear roller is a 3 inch
(76 mm) diameter steel full roller.
Replaceable single edged, high carbon steel bedknife is fastened to a machined cast iron
bedbar with 8 screws. The EdgeMax® bedknife is standard.
Dual screw adjustment to the reel; detents corresponding to .0009 inch (.023 mm) bedknife
movement for each indexed position.
Adjustable rear shield with optional adjustable cut-off bar to improve grass discharge from
reel in wet conditions.
A cast iron weight mounted opposite to the drive motor balances the cutting unit.
1650 RPM.
8 Blade – 147 lb. (67 kg) 11 Blade – 151 lb. (69 kg)
7
Advertisement
Table of Contents
