Toro 03681 Operator's Manual page 6

1. Counter weight
2. On right end of cutting unit, remove the plastic plug
from the bearing housing (Figure 7).
3. Remove the 2 cap screws from the right side plate
(Figure 7).
1. Plastic plug
4. Install the counter weight to the right end of the
cutting unit with the 2 screws previously removed.
5. Loosely install the 2 reel motor mounting cap screws
to the left side plate of the cutting unit (Figure 7).
Figure 6
Figure 7
2. Cap screw (2)
6