Seat Support / Fender Support
Service
Seat Support Removal
1. Raise seat and disconnect battery terminals.
2. Remove RH and LH pod / fender as shown in this
chapter.
3. Remove the (2) bolts that secure the hydro
expansion tank (A) to the seat support.
4. Remove the (1) fastener securing the fuel tank
retaining rod (B) to the seat support.
5. Remove the (2) thread-forming bolts that secure
the rear guard tube (C) to the seat support (E). OR
Remove the bolts / nuts securing the rear engine
guard to the ROPS frame (D) (Fig. 035).
D
E
Fig. 035
Toro TITAN 2009-2013 Service Manual
6. Remove the (2) bolts and nuts that secure the seat
7. Note the location of and remove any cable ties /
8. Remove the seat support bar from the frame.
(Fig. 036)
C
PICT-2070
support (E) to the frame brackets.
loom clamps securing wiring / cables to the seat
support bar (E).
A
B
Fig. 036
CHASSIS
C
3
E
PICT-2066
3-17