Toro 03634 Operator's Manual page 12

Adjusting the Height-of-Cut
Note: For heights of cut greater than 2.54 cm (1.000 inch)
the High Height-of-Cut Kit must be installed.
1. Loosen locknuts securing height-of-cut brackets to
cutting unit side plates
Figure 15
1. Adjusting screw
2. Locknut
2. Loosen nut on gauge bar
screw to desired height-of-cut.
Figure 16
1. Gauge bar
2. Height adjusting screw
3. Nut
3. Measure the distance between the bottom of the screw
head and the face of the bar to get the height-of-cut.
4. Hook the screw head on cutting edge of bedknife and
rest rear end of bar on rear roller
5. Rotate the adjusting screw until the front roller contacts
the gauge bar (Figure
until entire roller is parallel to the bedknife.
(Figure 15).
3. Height-of-cut bracket
(Figure 16) and set adjusting
4. Holes used for setting
Groomer HOG
5. Hole not used
(Figure 17).
17). Adjust both ends of roller
Important: When set properly, the rear and front
rollers will contact the gauge bar and the screw
will be snug against the bedknife. This ensures
that the height-of-cut is identical at both ends of
the bedknife.
6. Tighten nuts to secure adjustment.
Note: Do not overtighten nut. Tighten enough to
remove play from washer.
Use the following chart to determine which bedknife is
best suited for the desired height of cut.
Bedknife/Height of Cut Chart
Bedknife Bedknife Lip
EdgeMax® Low
HOC (03635)
Low HOC
(Optional)
Extended
EdgeMax® Low
HOC (Optional)
Extended Low
HOC (Optional)
EdgeMax®
(03634)
Standard
(Optional)
Heavy Duty
(Optional)
* Warm season grasses may require the Low HOC
bedknife for 12.7 mm (0.500 inches) and below.
12
Figure 17
Height of Cut
Height
5.6 mm 6.4-12.7 mm
(0.220 inch) (0.250-0.500 inch)
5.6 mm 6.4-12.7 mm
(0.220 inch) (0.250-0.500 inch)
5.6 mm 6.4-12.7 mm
(0.220 inch) (0.250-0.500 inch)
5.6 mm 6.4-12.7 mm
(0.220 inch) (0.250-0.500 inch)
6.9 mm 9.5-38.1 mm
(0.270 inch) (0.375-1.50 inch)*
6.9 mm 9.5-38.1 mm
(0.270 inch) (0.375-1.50 inch)*
9.3 mm 12.7-38.1 mm
(0.370 inch) (0.500-1.50 inch)