Inspecting The Rotor Blades - Toro 38536 Operator's Manual

Adjusting the Cable
1. Unhook the end of
the control cable from
the control bar.
2. Move the Z-fitting (A) to a higher or lower hole as
needed to obtain the 1/16 to 1/8 in. (2 to 3 mm) gap
between the control bar and the handle.
Note: Moving the Z-fitting higher decreases the gap
between the control bar and the handle; moving it
lower increases the gap.
3. Replace the spring cover and hook the end of the
control cable into the bottom hole of the control bar.
4. Check the adjustment (refer to Checking the
Cable on page 9).
Note: After extended use, the drive belt may wear
and lose its proper belt tension. If the drive belt slips
(continuously squeals) under a heavy load, increase
the belt tension by inserting the spring end into the
top hole of the control bar. The belt may slip (squeal)
in wet conditions; to dry out the drive system, start
the rotor and run it without a load for 30 seconds.
m-6201
A
m-6200
3327-933
10
Inspecting the Rotor
Blades
Before each season, inspect the rotor blades for
wear. When a rotor blade edge has worn down to the
wear indicator hole (A), have an Authorized Service
Dealer replace the rotor blades and the scraper.
A
m-6202