What To Do If; Care And Cleaning - Electrolux EXD25DN3W User Manual

WHAT TO DO IF...

Before calling for service, review this
list. It may save you time and expense.
This list includes common occurrences
PROBLEM
DEHUMIDIFIER DOES
NOT OPERATE
DEHUMIDIFIER RUNS
TOO MUCH
that are not the result of defective
workmanship or materials in this
appliance.
SOLUTION
Wall plug disconnected. Push plug firmly into wall
outlet.
House fuse blown or circuit breaker tripped. Replace
fuse with time delay type or reset circuit breaker.
The dryness level you selected has been reached.
Dehumidifier automatically shuts off when selected
amount of moisture has been removed from the
air. If you want to remove more moisture, Select
CONTINUOUS by using the humidity button or knob.
After the dehumidifier starts, reset the control to the
desired setting.
Bucket not installed properly. See "Removing
Collected Water".
Water in the bucket has reached its preset level.
Dehumidifier automatically turns off when this occurs.
Empty bucket and return bucket to position.
Dehumidifier is not turned on. Turn unit on.
BUCKET FULL light is on. Remove bucket, empty
water and re-install correctly.
Windows or doors near dehumidifier are open to
outdoors. Close all windows or doors to outside.
Area to be dehumidified is too large. Check with your
dealer to see if capacity is adequate.
Air movement through dehumidifier is blocked. Grill
may be dirty. Use brush attachment of vacuum
cleaner to clean grill. See "Care and Cleaning".
Dehumidifier must be placed in a space that does not
restrict air flowing into the rear coil or out of the front
grill.
Dehumidifier has been installed or restarted recently.
The higher the moisture in the room, the longer the
dehumidifier will operate.
Dehumidifier is in the CONTINUOUS mode and will
remain on in this mode, use the humidity button or
knob to set a RH% higher level.
ENGLISH 9