Adjusting The Gage Wheels - Toro 30319 Operator's Manual

Figure 23
1. Carrier Frame
2. Hairpin Cotter
3. Front height-of-cut post

Adjusting the Gage Wheels

The gage wheels need to be adjusted in the proper
hole location for each height-of-cut position.
There needs to be 3/8 inch (10 mm) minimum
clearance above the ground.
1. After adjusting height-of-cut, check the gage
wheels so that there is a minimum of 3/8
inch (10 mm) clearance above the ground
(Figure 24,Figure 25, Figure 26).
2. If adjustment is needed, remove the bolt,
washers and nut (Figure 24,Figure 25,
Figure 26).
3. Select a hole position so the gage wheels are a
minimum of 3/8 inch (10 mm) off the ground
(Figure 24,Figure 25, Figure 26).
4. Install the bolt, washers and nut
(Figure 24,Figure 25, Figure 26).
4. Spacers
5. Back height-of-cut post
Figure 24
1. Gage Wheels
2. Nut
Figure 25
1. Gage Wheels
2. Nut
3. Bolt
Figure 26
1. Center Gage Wheels and
spacer
2. Nut
25
3. Washer
4. Washer
5. Spacer
3. Bolt
4. Washer